The gas is colorless, odorless and non—poisonous. C92274 Place matchmarks on the steering intermediate shaft sub—assy and steering gear assy. Specified condition 1330Ω If the result is not as specified, replace the front seat inner belt assembly. Install the control valve housing to the rack housing with the 2 bolts. C90580 Fit the claws securely.
See page 12—1 See the table below for possible causes, and then inspect and correct the applicable causes if necessary. Select the active test mode on the hand—held tester. S04515 Apply battery positive voltage across the terminals. Piston Frozen 32—25 Brake pull 32—33 4. Reconnect the air inlet line hose to the charcoal canister. Connect the speed sensor connector. Do not run the engine when the fuel tank is nearly empty.
Parts must be reassembled within 10 minutes of application. Disconnect the pretensioner connector as shown in the illustration. C92274 Place matchmarks on the steering intermediate shaft sub—assy and steering gear assy. Carefully, remove the fuel tank assembly from the vehicle. If any fault is found, replace the vacuum check valve.
Hope this helps, the graciousness of a FixYa rating would be greatly appreciated. If continuity is not as specified, replace the magnet—clutch relay. Anti—squeal shim Damaged 32—25 32—33 10. Protrusion height: 3 mm 0. If the length is greater than maximum, replace the armature.
Remove the front suspension arm sub—assy lower No. Insert a compression gauge into the spark plug hole. Install the actuator to the bracket with the 2 nuts. Remove the 4 bolts and radiator support upper. Install the 2 bush dust boots to the each cylinder slide pin. Check that air flows from ports E to F.
B08663 Apply battery positive voltage across the terminals. Place the horn button assy in a vinyl bag, tie the end tightly and dispose of it in the same way as other general parts disposal. Remove the oil pressure switch. Use a step—down adapter for adjustment. Using an ohmmeter, check that there is continuity between terminal 50 and the switch body. Turn After installing injectors, check that they turns smoo- Connector thy. Loosen the tie rod end lock nuts.
Check that there are no fuel leaks after doing mainte- nance anywhere on the fuel system. Tire Worn or improperly inflated 28—1 2. Wheel alignment Incorrect 26—5 Abnormal tire wear 27—3 27—4 3. If continuity is not as specified, replace the heater blower motor relay. Next, mark the front side of each head bolt with a dot of paint.
Remove the synchronizer pull ring, synchronizer outer ring No. If there is continuity, replace the switch. Reconnect the air inlet line hose to the charcoal canister. If gas leakage is detected in a joint, check the torque of the joint. Specified condition No continuity Continuity If the result is not as specified, replace the front seat inner belt assembly. Check heated oxygen sensor operation. Remove 5 bolts and oil pump body cover.
Hope your repair goes well for you. Replace the drive belt if the belt has chunks missing from B00543 the ribs. Freeplay Rock the steering wheel gently up and down by your hand, check the steering wheel freeplay. Install the bolt and bracket. Place a new gasket on the oil pump. C03629 Install the rack steering piston ring to the power steering rack, and settle it down with your fingers.
Check push rod play and pedal free play. If the opening pressure is less than minimum, replace the reservoir cap. Tc terminal circuit 05—187 procedure. Replace any head bolt that will not torque to the above specs. Remove the 3 bolts, disconnect the steering column assy.